Drive Interface Identification And Settings; Configuring Network Settings - Overland Storage NEO 200S User Manual

NEO 200s/400s User Guide
• Logical Library 3 will contain Drive 3 and the lower right cartridge magazine.
• Logical Library 4 will contain Drive 4 and the upper right cartridge magazine.
NOTE: For more information about various configurations, see
The Mail Slot and slots reserved for cleaning cartridges, if any, are shared among all logical
libraries.
To configure the library access mode settings for the logical library:
1. Click Configure Library > Logical Libraries in the left navigation pane.
2. Select the number of logical libraries you would like to create in your library.
3. Click Submit to create the logical libraries.

Drive Interface Identification and Settings

1. Click Configure Library > Drives in the left navigation pane.
2. Select the desired settings for each drive listed (either SAS or Fibre Channel).
NOTE: If you have a Fiber Channel Drive connected to an AS/400 Host, direct attached to the
3. Click one of the following:
• Refresh – to update the current screen
• Submit – to apply the changes made to the screen

Configuring Network Settings

This page shows the current network configuration of the library and allows modification to
the configuration. When a change is requested, a pop-up box confirms the request.
1. Click Configure Library > Network in the left navigation pane, to display the Network
page.
10400367-001 04/2012
Addressing" on page 3-1.
Fiber HBA, set the Port Type to L-Port.
©2012 Overland Storage, Inc.
Configuring Your Library – Web User Interface
"Library Partitioning and Element
4-13