Overland Storage NEO 200S User Manual page 85

NEO 200s/400s User Guide
1. Click Network in the left navigation pane to display the Network page.
made until after the library has applied the current changes. After the Submit button has
been clicked, depending on the changes made, you will either be disconnected and need
to login again or reboot the library. Clicking the Refresh button will refresh the page and any
changes made will not be retained.
2. Choose the Network settings:
• Protocol Stack – Choose IPv4 only, IPv6 only, or Dual Stack IPv4 & IPv6.
• Host Name.
• Domain Name.
• DNS Primary – Enter the IP address of your primary DNS server.
• DNS Secondary – Enter the IP address of your secondary DNS server.
• Enable SSL for Web – If you desire to have SSL (Secure Sockets Layer) enabled,
Ethernet Settings – Ethernet Settings choices are: Auto (the default), 10 Mbit/Half, 10
Mbit/Full, 100 Mbit/Half, 100 Mbit/Full.
3. Enter IPv4 settings (if applicable):
• Enable DHCP – Click this item ON to have the IP Address of your library
• Static Address – Enter the assigned IPv4 address. The format of an IPv4 IP
10400367-001 04/2012
IMPORTANT: Do not click the Submit button until all changes have been made to the
Network page. Once the Submit button has been clicked, no other changes can be
If you choose Dual Stack IPv4 & IPv6, you must be prepared to enter both IPv4
and IPv6 IP addresses. The sections below will gray out depending on the choices
made here.
place a check in this box.
NOTE: If you get a security certificate alert when logging in to the Web User Interface, you
can install the certificate or allow an exception (depending on the internet browser
you are using). SSL is enabled when the URL begins with https:// and some
browsers will show a lock.
automatically set by the DHCP server.
address is a 32-bit numeric address written as four numbers separated by periods.
©2012 Overland Storage, Inc.
Web User Interface Menus
5-21