Install Any Add-On Components - Overland Storage NEO 200S User Manual

NEO 200s/400s User Guide
2. Install the library rack anchor "donuts" ( ) on each side of your library using the M3
x 6 counter-sunk screws included in the rack kit.
3. Install the library mounting brackets ( ) as shown on each side of the 2U library
using the screw that was removed from your library and an additional M3 x 4
counter-sunk screw included in the rack kit.
The 4U rack anchors and mounting brackets are similar.
Insert the Library in Rack
WARNING:
raise and align the unit to prevent injury during installation. Use care when inserting or
removing a unit into or out of a rack to prevent the accidental tipping of the rack, causing damage
or personal injury.
AVERTISSEMENT:
monte-charge (ou au moins deux personnes) pour élever ou aligner l'appareil. Faites attention
lorsque vous insérez ou retirez l'appareil d'un support, pour empêcher le déversement accidentel
de la crémaillère causant des dommages et des blessures.
1. Using the mechanical lifter, position the library in front of the rack, aligned with the
rails.
2. Slide the library onto the rails until the mounting brackets are up against the
vertical rack rails.
The "donuts" on the side of the library should be under the side bump-out slots at the
rear of the rails.
3. Secure it to the rack with the captive screws.

Install Any Add-on Components

The NEO 200s/400s libraries are expandable and accept add-on components to enhance
performance:
10400367-001 04/2012
M3 x 6a with
It is recommended that a mechanical lifter (or at least two people) be used to
Afin d'éviter des blessures pendant l'installation, il est recommande d'utiliser un
©2012 Overland Storage, Inc.
"Donut"
"Donut"
M3 x 4
Previously Removed Screw
Installing in a Rack
4-5