Overland Storage NEO 200S User Manual page 86

NEO 200s/400s User Guide
• Network Mask – Enter the assigned IPv4 Network Mask.
• Gateway Address – Enter the assigned IPv4 Gateway address. This address
4. Enter IPv6 settings (if applicable).
• Enable DHCP – Click this item ON to have the IP Address of your library
• Enable Stateless Auto Config – Click this item ON to have the IP Address of
• Static Address – Enter the assigned IPv6 address. The format of an IPv6 IP
• Prefix Length – The default prefix length is set to 64, but can be set to any
• Gateway Address – Enter the assigned IPv6 Gateway address. This address
5. Click one of the following:
• Refresh – to cancel the changes made to the screen.
• Submit – to apply the changes made to the screen.
NOTE: Depending on the changes made, you will either be disconnected and need to login again,
Configure Library: User Access
This page allows the user to add and modify user accounts. See
information on user types.
The Configure Library: User Access page is only accessible to the Admin and Service login.
Access is denied to User and Superuser logins.
• The Admin login has access to all library functions except Service Library > Advance
Diagnostics.
• The Service login has access to all library functions including Service Library >
Advance Diagnostics.
The following elements are displayed on the User Access page:
10400367-001 04/2012
allows access outside the local network.
automatically set by the DHCP server.
your library automatically set by the network router.
address is a 128-bit numeric address written as 8 groups of four numbers
separated by colons.
length, depending upon the address used.
allows access outside the local network.
or reboot the library. If a reboot is required, a Warning message appears after the Submit
button is clicked.
©2012 Overland Storage, Inc.
Web User Interface Menus
"Login" on page 2-6 for
5-22