Configure Library Settings; Using Factory Defaults As Your Configuration; Configuring Your Library - Web User Interface - Overland Storage NEO 200S User Manual

NEO 200s/400s User Guide

Configure Library Settings

The library can be configured using the Web User Interface and/or the Operator Control
Panel. The recommended method for configuring your library is using the Web User
Interface. See
"Configuring Your Library – Operator Control Panel" on page
For complete detailed information on all of the functions available on the library using both
the Operator Control Panel and the Web User Interface, see

Using Factory Defaults as Your Configuration

The table below shows the main default library settings. If you wish to use the defaults, no
other changes need to be made before using your library.
For a full list of factory defaults, see
Configuring Your Library – Web User Interface
If you choose to use the Web User Interface to configure your library, first enter your library
network settings using the Operator Panel (see
page 4-23).
NOTE: To access the Web User Interface, be sure Java 1.5.0 or higher is installed on your host
Topics in Configuring Your Library – Web User Interface:
• Establishing Remote Access to Your Library
• Logging in to the Web User Interface
•
Checking Firmware Level
• Configuring Library Settings
•
Drive Interface Identification and Settings
• Configuring Network Settings
• Configuring User Access
10400367-001 04/2012
"Configuring Your Library – Web User Interface" on page 4-8
Item
Logical Libraries
Active Slots
I/O Slots
DHCP
Internet Protocol
Bar Code Label Length
Library Mode
Auto Clean
IPv6 Stateless Autoconfig
computer. Download the latest version of the Java Runtime Environment (JRE) for your
platform from http://www.java.com/.
©2012 Overland Storage, Inc.
Default Setting
1
Maximum
Enabled
Enabled
IPv4 Only
8
Random
Disabled
Enabled
"Configuring Save/Restore Settings" on page
"Configuring Network Settings" on
Configure Library Settings
and
4-19.
Chapter 5, "Operations."
4-25.
4-8