Overland Storage NEO 200S User Manual page 131

NEO 200s/400s User Guide
Error Code Description
39 SCSI: parameter list error: invalid field
3A SCSI: parameter list error: parameter
not supported
3B SCSI: parameter value invalid
3C SCSI: saving parameters not supported
3D SCSI: invalid ID message
3E SCSI: destination element full
3F SCSI: source slot or drive empty
40 SCSI: wrong checksum
41 SCSI: command sequence error
42 SCSI: drive disabled
43 SCSI: I/O Station (Mail Slot) disabled
44 SCSI: flash image does not fit boot code
45 SCSI: media removal prevented by drive
46 SCSI: media removal prevented by
library
47 SCSI: flash image does not fit
personality
48 SCSI: drive type not supported in this
library
49 SCSI: incompatible magazine,
magazine not accessible
4A SCSI: source not ready
4B SCSI: destination source not ready
4C SCSI: library controller busy
4D SCSI: cannot make reservation
4E SCSI: invalid slave robotic controller
request
4F SCSI: robotic axes/motors aren't
initialized
50 SCSI: cartridge belongs to another
partition
55 SCSI: invalid license key entered
58 Recovered Error: SCSI parity error
59 Recovered Error: Error log overflow
5B Incompatible medium generation
5C Illegal request, downgrade prohibited
because of incompatible network stack
5D Illegal request, wrong drive FW for drive Obtain correct drive firmware image.
5E Full high drive in illegal position
10400367-001 04/2012
User Action
Refer to your host application documentation for problem
determination information.
Check your configuration settings.
Refer to your host application documentation for problem
determination information.
Check the version of firmware used for the upgrade.
Check whether a version of firmware is available which supports
this drive type. For a list of supported drives, refer to Ultrium Tape
Drives.
Check your configuration settings.
Complete move process and retry operation.
Complete process and retry operation.
Refer to your host application documentation for problem
determination information.
Check robotics status. Refer to Isolating a Library Controller Card vs.
Accessor Enclosure Problem.
Refer to your host application documentation for problem
determination information.
Re-enter license key. If problem persists, contact Overland
Technical Support.
No user action is required.
Replace incorrect cartridges.
Change network settings to IPv4 only before downgrading firmware.
Check correct Drive position.
©2012 Overland Storage, Inc.
Warning Events
8-10