Overland Storage NEO 200s Instructions

Spare Power Supply Instructions
This document describes how to remove and replace a power
supply module in a NEO 200s/400s library from Overland
Storage.
WARNING: To reduce the risk of electric shock or damage to
equipment, always remove any power cords while working
with the unit.
AVERTISSEMENT: Pour réduire le risque de choc électrique ou
endommagement de l'équipement, retirez toujours les cordons
électriques en travaillant avec l'appareil.
CAUTION: While working with the unit, observe standard
Electrostatic Discharge (ESD) precautions to prevent damage
to micro-circuitry or static-sensitive devices.

Remove Old Power Supply

1. Power OFF the library by pressing and holding down the
power button on the front for four seconds.
2. Disconnect any power cords from the electrical source,
then from the library.
3. Loosen the three blue captive thumbscrews on the
defective power supply.
4. Pull on two of the thumbscrews to pull the unit away from
the rear panel of the library, then grasp the top and
bottom edge of the power supply and pull it out of the
library.

Install New Power Supply

1. Grasp the top and bottom edge of the power supply and
push it into the empty bay in the library.
2. Tighten the three blue captive thumbscrews
the power supply to secure it.
3. Connect all the power cords to the library
the electrical source.
10400372-001 03/2012
( )
on
( ) , then to
©2012 Overland Storage, Inc.
NEO 200s/400s
®
Page 1 of 2