Totalstorage Tape Diagnostic Tool (Itdt) - Overland Storage NEO 200S User Manual

NEO 200s/400s User Guide
2. At the rear, locate the access holes for the right and left magazines.
3. To manually release the magazines, push the end of a straightened paper clip into
the access hole for each magazine at the back of the library. While holding the paper
clip, have a second person pull the magazine out of the front of the unit. DO NOT
push the paper clip in more than 1/2 inch.
4. If there are additional tapes still in the library, or if you were unable to manually
remove the magazines and drive, contact Overland Technical Support for further
instructions.

TotalStorage Tape Diagnostic Tool (ITDT)

The TotalStorage Tape Diagnostic Tool (ITDT):
• Runs quick or extended diagnostics on tape drives. If the library is online to the
server/host where the tool resides, ITDT will communicate with the drive through the
library to load and unload a test cartridge thereby exercising some library functions.
• Retrieves firmware dumps from tape drives and libraries.
• Performs a firmware update on tape drives or libraries. See note below regarding
library firmware update.
• Tests the performance of the environment by completely writing a cartridge and
measuring performance.
• Retrieves and displays cartridge information.
• Verifies the encryption environment.
10400367-001 04/2012
Right Magazine Release
(next to Power Supply)
2U Left Magazine Pulled Out
©2012 Overland Storage, Inc.
TotalStorage Tape Diagnostic Tool (ITDT)
Left Magazine Release
(next to Port Panel)
4U Magazines Pulled Out
9-2