Configuring A Fibre Channel Drive - Overland Storage NEO 8000e User Manual

NEO 8000e User Guide

Configuring a Fibre Channel Drive

In most cases, you can use the default configuration values for Fibre Channel
drives. However, if it becomes necessary to change the default values, these values
are editable:
• Port n Control
• Port n Loop ID
• World Wide Port n Name
• World Wide Node Name
• Topology
• Speed
• Directory Registration
Table 5-6
settings available. The information in this section shows you how to make those
changes.
1. From the front panel Default screen, press Menu.
2. In the Edit Options area, press SCSI/FC to edit the host interface.
The initial FC screen is shown
3. If necessary, use the arrow buttons to scroll down to locate the drive being
4. Press the Set Values button to the right of the tape drive you are changing.
10400293-002 01/2011
in Chapter 5, "Using the Front Panel Interface,"
NOTE: If a Service password is enabled, the validate password screen is displayed.
Enter the correct password and press Validate.
Figure 3-11: FC Initial Screen (Edit Options)
changed.
The Set Values edit screen (Edit Drive Configuration) is displayed
12).
©2005-11 Overland Storage, Inc.
(Figure 3-11).
Installation and Initialization
details all the different
(Figure 3-
3-9