Establishing Remote Access To Your Library - Overland Storage NEO 200S User Manual

NEO 200s/400s User Guide
• Configuring Date and Time Settings
• Configuring Logs and Traces
• Configuring Email Notifications
• Configuring SMNP Settings
•
Restoring Factory Default Settings
• Logging Out

Establishing Remote Access to Your Library

Static library network settings must be entered using the Operator Control Panel before
the library can be accessed remotely using the Web User Interface. If your system is
serviced by DHCP (Dynamic Host Configuration Protocol) server, the network parameters
will be automatically set. Once remote access has been established, you can complete the
configuration of your library using the Web User Interface.
1. Using the Operator Control Panel, at the Home screen, select the Configure menu.
2. Go to Network > IP STACK and select the Internet Protocol.
3. If you select IPv6 protocol, the Configure Network menu will include options for
Stateless Autoconfig and Prefix length.
• Select the Stateless Autoconfig option desired.
• Select the Prefix Length.
4. If desired, select DHCP as your library network setting:
a. Select the DHCP field.
b. Press the DOWN button to select ON.
c. Press the SELECT button to apply your selection.
Skip to
5. Press the DOWN button to select a static IP Address.
For IPv4, enter only an IPv4 address. For IPv6, enter only an IPv6 address. For both
IPv4 & IPv6, enter an IPv4 address and an IPv6 address.
a. Press the SELECT button to highlight the IP Address field.
b. Press the UP or DOWN button to select the digits in the first octet of the
c. Repeat
d. Press the SELECT button to apply your entries.
6. Repeat
• Netmask
• Gateway
7. Press the DOWN button to select Ethernet and change the setting.
8. Highlight SAVE and press the SELECT button to apply your new configuration.
If changes were made to the Network settings, a pop-up menu will display the option
to reboot the library or cancel the reboot. If you select CANCEL in the pop-up menu,
you will need to power cycle the library for the network changes to be applied.
NOTE: Instead of SAVE, you can select CANCEL to cancel all of your entries and return to the
10400367-001 04/2012
Step 7.
IP Address, and press SELECT.
Step b for the remaining octets.
Step 5 for each of the following:
Configure menu.
©2012 Overland Storage, Inc.
Configuring Your Library – Web User Interface
4-9