Overland Storage NEO 200S User Manual page 150

NEO 200s/400s User Guide
Flag Number Flag Name
56 Unload failure
59 WORM Media integrity
check failed
60 WORM Media
overwrite attempted
10400367-001 04/2012
Description
Set when a drive hardware error
prevents the tape cartridge from
being unloaded from the tape drive,
or when the tape cartridge is stuck in
the drive.
Set when the drive determines that
the data on the tape is suspect from
a WORM point of view.
Set when the drive rejects a write
operation because the rules for
allowing WORM writes have not been
met. Data can only be appended to
WORM media. Overwrites to WORM
media are not allowed.
©2012 Overland Storage, Inc.
Tape Drive Supported TapeAlert Flags
Action Required
1. Unload the cartridge from the drive
using the Operator Panel or the Web
User Interface.
2. Try a power cycle of the entire library.
This causes the drive to reset and
attempt to rewind and unload when
power is restored. If the cartridge
unloads, remove it from the library and
inspect it. If damaged, discard it.
3. Try to unload the cartridge from the
drive again using the Operator Panel or
the Web User Interface.
4. If the cartridge will still not unload from
the drive, contact Overland Technical
Support.
1. Copy the data to another WORM tape
cartridge.
2. Discard the old WORM tape.
Append the information on a WORM tape
cartridge or write the data to a non-WORM
cartridge.
C-6