Overland Storage NEO 200s Instructions

Spare Library Controller Card Instructions
This document describes how to remove and replace a library
controller card in a NEO 200s/400s library from Overland
Storage.
WARNING: To reduce the risk of electric shock or damage to
equipment, always remove any power cords while working
with the unit.
AVERTISSEMENT: Pour réduire le risque de choc électrique ou
endommagement de l'équipement, retirez toujours les cordons
électriques en travaillant avec l'appareil.
CAUTION: While working with the unit, observe standard
Electrostatic Discharge (ESD) precautions to prevent damage
to micro-circuitry or static-sensitive devices.

Prepare the Unit

IMPORTANT: The Library Controller Card contains a copy of the vital product data (VPD), or configuration, for your library. You must
backup the VPD (if possible) for transfer to the replacement chassis.

Save Library Configuration

If possible, save the current configuration of the library:
1. Plug a USB drive into the rear panel.
2. At the Operator Control Panel, press
Restore > Save Library Config.

Exchange Controller Card

Remove the Old Card

1. Power OFF the library by pressing and holding down the
power button on the front for four seconds.
2. Disconnect any power cords from the electrical source,
then from the library.
3. Loosen the two blue captive thumbscrews on the
controller card located on the right side of the back panel.
4. Grasp the two thumbscrews and pull the defective
Library Controller Card out of the library.

Insert the New Card

1. Grasp the two thumbscrews
Library Controller Card and push it into the library.
2. Tighten the two blue captive thumbscrews to secure it.
3. Connect all the power cords to the library
the electrical source.
10400373-001 03/2012
Configure > Save/
( )
on the replacement
( ) , then to
©2012 Overland Storage, Inc.
NEO 200s/400s
®
Page 1 of 2