Configuring A Fibre Channel Drive - Overland Storage NEO 8000 User Manual

Chapter 4: Daily Operation
4. Press the virtual button to the right of the tape drive you are changing.
The Bus ID edit screen is displayed
5. Press one of the SCSI ID number buttons for the new ID and press Save.
6. At the Confirm dialog box, press either OK to accept or Cancel to discard the change.
NOTE: If you enter a ID number that is already assigned, you are prompted to accept the
duplication
The newly selected SCSI ID flashes for a few seconds while the drive is being updated,
then stops indicating that the operation is complete.
7. Press Back twice to return to the Default screen.

Configuring a Fibre Channel Drive

In most cases, you can use the default configuration values for Fibre Channel drives.
However, if it becomes necessary to change the default values, these values are editable:
• Port n Control
• Port n Loop ID
4–2
10400267-101 09/2009
(Figure
Figure 4-2: Bus ID Edit Screen
4-3).
(Figure
Figure 4-3: Bus ID Confirmation Dialog Box
4-2).