Overland Storage NEO 200S User Manual page 15

NEO 200s/400s User Guide
Number Item
10400367-001 04/2012
Power connectors
Host interface connectors The library has one or more of the following host interface
Tape drive sled
Shipping lock and label
storage location
USB port
Library Control Board
(LCC) LED
Serial port
Ethernet port
Tape drive LED
Machine type, Model
number, and Serial
Number pull-out label
Fan vents
ESD label
©2012 Overland Storage, Inc.
Description
The libraries require a 110/220 volt AC power connection.
• The 2U library has one power supply.
• The 4U library has a minimum of one power supply, but has the
capability of adding a redundant power supply.
connectors on the drive sled:
• SFF-8088 mini-SAS connector
• Fibre Channel connector
This library supports the Ultrium 4 and Ultrium 5 tape drives. The
tape drive in the library is packaged in a container called a drive
sled. Drive sleds come in a full high or Half-Height configuration.
The drive sled is a customer replaceable unit (CRU), and is hot-
pluggable, which is designed for easy removal and replacement.
The shipping lock, which secures the accessor during shipping,
and associated label are stored on the rear panel of the library for
future use. See Removing and Storing the Shipping Lock.
CAUTION: The shipping lock must be removed before
powering ON the library to allow the accessor to
function properly.
Used to save/restore library configuration information on a USB
device.
An LED showing the status of the Library Control Board. The LED
flashing (1 flash per second) is normal operation.
This port is used to communicate serially with the library using an
RJ-11 connector. For use by Overland service personnel.
This port is used to connect the library to a network.
• 10/100 Link LED
• Description: Green; indicates link integrity
• Flashing: Network synchronization/negotiation
• Steady (On): Good connection
• Off: No connection between NIC and hub
• Activity LED
• Description: Amber; indicates port traffic
• Flashing: Network traffic present
• Steady (On): Heavy network traffic
• Off: No traffic
This LED indicates the current status of the drive. When the LED
is green, it indicates normal drive activity.
The machine type, model number and serial number of the library
are located on this pull-out label. This serial number is the
number that links the library to your warranty.
These vents allow air to escape from the power supply and tape
drive sled.
The Electrostatic Discharge label is a reminder that some of the
components of this library are susceptible to electrostatic
discharge. See the "Preface."
Physical Library
1-4