13.2.2 Removing the front LAN connector
Field Replaceable Units (FRU)
Average task duration: 10 minutes
13.2.2.1 Required tools
Preliminary and concluding steps: tool-less
●
Removing the front LAN connector:
●
– Phillips PH2 / (+) No. 2 screw driver
13.2.2.2 Preliminary steps
Before removing the front LAN connector, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê If applicable, open the rack door as described in section
door" on page
Ê Locate the desired server as described in section
server" on page
Ê Shut down the server as described in section
page
61.
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Bring the server to its horizontal position.
Ê Open the side / top cover as described in section
on page 67
(rack server) or
server).
TX140 S1
93.
61.
54.
"Disconnecting power cords" on page
"Extending the server out of the rack" on page
"Removing the side cover" on page 71
Upgrade and Maintenance Manual
Front panel and external connectors
"Locating the defective
"Shutting down the server" on
66.
"Removing the top cover"
"Disabling BitLocker
"Opening the rack
63.
65.
(tower
399