Connecting Cables To The Pci Expansion Unit - Fujitsu SPARC M12-1 Installation Manual

Secure cables to the CMA.
6.
a. Pull out the chassis until the CMA is fully extended.
b. Bundle cables such as the power cords, LAN cables, and FC cables, and
c. Put the chassis back into the rack.
Note - Ensure that the FC cable, when secured, has a bend radius of 30 mm (1.2 in.) or more.
Check the movement of the CMA.
7.
a. Pull out the chassis slowly to check whether it moves smoothly.
b. Confirm that the laid cables are not twisted.
4.2 Connecting Cables to the PCI
Expansion Unit
This section describes the procedure for connecting the management cable, link
cables, and power cords to the PCI expansion unit.
1. Connect the management cable.
Connect the link board of the PCI expansion unit and the link card of the chassis
by using the management cable. (See A in
2. Connect link cables.
Connect the cables such that the port indications on the link card and link board
match the labels on the cables.
Each port on the link card and link board is color-coded and numbered. Connect
the port to the corresponding port of the same color and number.
Note - The two link cables are the same. The labels on both ends of each cable have the same
indications. When laying the cables, check their connections to confirm that the ends of the
cables connected to the link card and link board are at the same ports shown on the labels.
Figure 4-6 Link Cable (Optical) Shape
a. Connect one end of a link cable to the port (B in
70 Fujitsu SPARC M12-1 Installation Guide ･ June 2021
secure them with the cable clamp on the CMA.
mounted in the PCI expansion unit.
Figure 4-7 and A in Figure
Figure 4-7) on the link board
4-8.)