Isuzu 1999 RODEO Workshop Manual page 1528

DTC P0342 —CMP Sensor Circuit Low (Cont'd)
Step
12 1. Ignition "ON."
2. Remove the CMP sensor.
3. Place a magnet on the CMP sensor. If you use a
magnet that is too small to cover the face of the
sensor, test on every part of the sensor face
because only a small area will respond to this test.
Does the DVM display a voltage near the specified
value?
13 Replace the camshaft position sensor.
Is the action complete?
14 Replace the PCM.
NOTE: The replacement PCM must be programmed.
Refer to On-Vehicle Service in Powertrain Control
Module and Sensors for procedures.
And also refer to latest service bulletin.
Check to see if the Latest software is released or not.
And then Down Load the LATEST PROGRAMMED
SOFTWARE to the replacement PCM.
Is the action complete?
RODEO 6VD1 3.2L ENGINE DRIVEABILITY AND EMISSIONS
Action Value(s) Yes
0 V Go to Step 14
— Verify repair
— Verify repair
6E2–285
No
Go to Step 13
—
—