Rmon Probe Defaults; Quick Steps For Enabling/Disabling Rmon Probes - Alcatel OmniSwitch 6600 Family Network Configuration Manual

Diagnosing Switch Problems

RMON Probe Defaults

The following table shows Remote Network Monitoring default values.
Global RMON Probe Defaults
Parameter Description
RMON Probe Configuration

Quick Steps for Enabling/Disabling RMON Probes

1 Enable an inactive (or disable an active) RMON probe, where necessary. You can also enable or
disable all probes of a particular flavor, if desired. For example:
-> rmon probes stats 4005 enable
-> rmon probes history disable
2 To verify the RMON probe configuration, enter the
for the type of probe. For example, to display the statistics probes, enter the following:
-> show rmon probes stats
The display is similar to the one shown below:
Entry Slot/Port
-----+-----------+-----------+----------+---------------+---------------------
4001 4/1
4008 4/8
4005 4/5
3 To view statistics for a particular RMON probe, enter the show rmon probes command, with the
keyword for the type of probe, followed by the entry number for the desired RMON probe. For example:
-> show rmon probes 4005
The display will appear similar to the one shown below:
Probe's Owner: Hawk Switch Auto Probe on Slot 4, Port 5
Entry 4005
Flavor = Ethernet, Status = Active
Time = 0 hrs 03 mins,
System Resources (bytes) = 275
For more information about these commands, see
"Displaying Statistics for a Particular RMON Probe" on page 27-29
in the OmniSwitch CLI Reference Guide.
OmniSwitch 6600 Family Network Configuration Guide
CLI Command
rmon probes
Flavor Status
Ethernet Active
Ethernet Active
Ethernet Active
"Displaying a List of RMON Probes" on page
April 2006
Remote Monitoring (RMON) Overview
Default Value/Comments
No RMON probes configured.
show rmon probes command with the keyword
Duration System Resources
00:25:00 275 bytes
00:25:00 275 bytes
00:03:03 275 bytes
or the "RMON Commands" chapter
27-28,
page 27-9