Reset Processing State; Section 7.4 Reset Processing State - Motorola DSP56000 Manual

24-bit digital signal processor
Hide thumbs Also See for DSP56000:
Table of Contents

Advertisement

mented to one (see Figure 7-13). During the execution of n2 in Figure 7-13, no interrupts
will be serviced. When LC finally decrements to one, the fetches are reinitiated, and
pending interrupts can be serviced.
Sequential REP packages will cause pending interrupts to be rejected until the sequence
of REP packages ends. REP packages are not interruptible because the instruction
being repeated is not refetched. While that instruction is repeating, no instructions are
fetched or decoded, and an interrupt can not be inserted. For example, in Figure 7-14, if
n1, n3, and n5 are all REP instructions, no interrupts will be serviced until the last REP
instruction (n5 and its repeated instruction, n6) completes execution.
7.4

RESET PROCESSING STATE

The processor enters the reset processing state when a hardware reset occurs and the
external RESET pin is asserted. The reset state:
1. resets internal peripheral devices;
2. sets the modifier registers to $FFFF;
3. clears the interrupt priority register;
4. sets the BCR to $FFFF, thereby inserting 15 wait states in all external memory
accesses;
5. clears the stack pointer;
6. clears the scaling mode, trace mode, loop flag, double precision multiply
mode, and condition code bits of the SR, and sets the interrupt mask bits of
the SR;
7. clears the data ROM enable bit, the stop delay bit, and the internal Y memory
disable bit, and
8. the DSP remains in the reset state until the RESET pin is deasserted.
When the processor deasserts the reset state:
9. it loads the chip operating mode bits of the OMR from the external mode select
pins (MODA, MODB, MODC), and
10. begins program execution at program memory address defined by the state of
bits MODA, MODB, and MODC in the OMR. The first instruction must be
fetched and then decoded before executing. Therefore, the first instruction
execution is two instruction cycles after the first instruction fetch.
MOTOROLA
RESET PROCESSING STATE
PROCESSING STATES
7 - 33

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dsp56k

Table of Contents