Preparing For Installation; Situating The Printer; Installing The Media Roll Holder - Intermec 4400 User Manual

4400 Bar Code Label Printer User's Manual

Preparing for Installation

2-4
Before you connect the printer to your system, make sure that you have chosen
a proper physical location for the printer and that you have installed the media
roll holder. Also, print a configuration test label by following the instructions in
Chapter 1 or in the 4400 Bar Code Label Printer Getting Started Guide.

Situating the Printer

When choosing a physical location for the printer, use the following guidelines:
Choose a location within 5 feet (1.5 meters) of an electrical source.
Set the printer up on a level, sturdy surface.
Allow easy access to the power switch and the rear panel.
Make sure the grill covering the fan is kept clear of obstructions and debris.
Keep water and other liquids away from the printer.

Installing the Media Roll Holder

The 4400 printer accepts both fanfold and roll media. If you are planning to
use roll media, install the Media Roll Holder as shown below.
If you are using fanfold media, skip this procedure.
To install the media roll holder
1. Open the printer and lift the cover.
2. Insert the tabs at the ends of the arms into the slots at the back of the
printer as shown in the figure below. Make sure the holder is installed
securely before loading roll media. Refer to the following illustration.