Installing Options - Intermec 4400 User Manual

Note: Setting the Max Print Speed does not limit the print speed that you can select. It
only limits the range of the selections from the control panel. By sending the <SI>S
configuration command from the host, you can set any print speed up to 10 ips.
However, if you use the control panel to scroll to another print speed, you cannot
return to a speed above 6.0 ips without again sending the <SI>S command.
To set the maximum print speed
1. Start at the OFFLINE READY display.
2. Press [MENU]. Then press [ ] or [ ] until the display shows the following:
3. Press [SELECT]. Then press [ ] or [ ] until the display shows:
4. Press [SELECT] to enter the Max Print Speed menu.
5. Press [ ] or [ ] to select from values of 2.5 ips to 10 ips.
6. Press [ENTER] at the desired print speed for your application. The display
7. Press [CONTINUE] to return to the OFFLINE READY screen.

Installing Options

This is a special procedure to be done only if the option software drivers are
unloaded. This can happen if you use Memory Reset to set the configuration
parameters back to their default values.
Note: Enabling or disabling options does not unload the software drivers. After you
install an option, be sure to enable the option.
Printer options such as self-strip and cutter are installed at the factory. These
options are controlled by software drivers that reside in the printer's internal
software. If the software driver is unloaded, the option cannot function
properly, and the enable/disable commands for your options will not appear
in the Configuration menu.
The software drivers will be unloaded if you use the memory reset command
to reset the configuration parameters. This procedure for loading options is
provided in case you use memory reset or the options software drivers are
unloaded by any other means.
OFFLINE
INSTALL MENU
INSTALL MENU
MAX PRINT SPEED
shows the current setting with an asterisk (*) as in the example below:
MAX PRINT SPEED
6.5 INCH/SECOND*
Special Procedures
8
8-13