Setting The Media Alert - Intermec 4400 User Manual

4400 Bar Code Label Printer User's Manual
5. Press the up or down arrow key ([ ]or [ ]) until the display shows:
6. Press the [SELECT] key.
7. Press the up or down arrow key ([ ] or [ ]) until the display shows:
8. Press the [SELECT] key.
9. Press the up or down arrow key ([ ] or [ ]) until the correct width appears
10. Press the [CONTINUE] key. The printer returns to Offline status.
11. To return the printer to Online status, press the [ONLINE/OFFLINE] key.

Setting the Media Alert

The Media Alert feature can warn you when your media supply is getting low.
When set, it causes the Alert light to flash when the label stock supply gets
down to a preset level. You can also set an audible alarm.
Note: Be sure to reset the media length and low media warn each time a different size
roll of media into the printer. If this is not done, the printer may not give sufficient
warning of a low media condition.
To use the Media Alert, you set three control panel commands that give the
printer the information it needs to run the alert. These commands are
summarized in the table below. The default settings are in bold.
Command Settings
Media Length
0 to 99999 in. or 0 to
9999999 mm.
Low Media Warn
0 to 999 in. or 0 to 99999
mm.
Set Warning
Enabled, Disabled
5-14
CONFIGURATION
LABEL
LABEL
LABEL WIDTH
in the display. Then press the [ENTER] key. An asterisk appears next to the
setting.
Description
Sets the media supply length (in inches or millimeters),
so the printer can count backwards down to the low
media warning point
Sets the minimum amount media supply. When the
media reaches this amount, the alert light and low media
warning are activated.
Enables or disables the Media Alert feature.