Printing A Copy Of The Data From The Host - Intermec 4400 User Manual

5. Press [ ] or [ ] until the display shows the number of the page you want to
6. Press [SELECT]. This display shows one of the following prompts:
7. Press [ENTER] at the EXECUTE TEST prompt to print.

Printing a Copy of the Data From the Host

If you need to see a hard copy of the data being sent to the printer, you can set
the printer to print out all data and commands it receives from the host.
This feature is available through the Data Line Print command in the Service
menu. You have two selections for Data Line Print:
Enabled The printer prints all ASCII characters it receives from the host,
including control characters. The corresponding hexadecimal code is printed
underneath each character.
Disabled The printer prints normally. This is the default setting.
To enable or disable Data Line Print
1. Start at the OFFLINE READY display.
2. Press [MENU] to enter the main menu. Press [ ] or [ ] until you reach the
3. Press [SELECT] to enter the Service menu. Press [ ] or [ ] until the display
NugFont
HelvC
print.
Note: You can select all pages by pressing [ ] to select ALL.
PRINT PAGE
ALL
If you selected all pages, all formats, or any selection of fonts or
graphics, the display shows:
PAGE ALL
EXECUTE TEST
If you selected a specific page or format, the display shown below
appears. Press [ ] or [ ] until you reach the number of copies of the
selected page or font you want to print, and then press [SELECT].
PAGE QUANTITY
1
Service menu.
shows:
SERVICE MENU
DATA LINE PRINT
C o d e 3 9
Troubleshooting
9
9-15