Increasing Available Memory - Intermec 4400 User Manual

6. If you are using gapped media, press [ENTER]. If you are using marked
7. Hold down the [FEED/RELOAD] key while the printer feeds two labels
After the labels are forwarded, the label sensors are calibrated. Press
[CONTINUE] to return to the READY display.

Increasing Available Memory

If you need to increase the amount of memory available in your printer, you
can use one of the Service memory reset menus to clear fonts/graphics or
pages/formats stored in battery backed RAM. Using either of these commands
will destroy any data that you have previously downloaded. It is necessary to
redownload any important fonts/graphics or pages/formats that you have just
cleared from memory.
To increase available memory
1. Start at the OFFLINE READY display.
2. Press [MENU]. Then press [ ] or [ ] until you see the following display:
3. Press [ ] until the display shows:
4. Press [SELECT]. The display shows:
5. Press [ ] until the display shows:
6. Press [ENTER] to clear fonts/graphics or pages/formats.
NugFont
HelvC
media, press [ ] or [ ] to choose Mark, and then press [ENTER]. The
display shows:
HOLD FEED KEY
FOR TWO LABELS
forward. The display shows:
CALIBRATE SENSOR
GAP
OFFLINE
SERVICE MENU
SERVICE MENU
MEMORY RESET
MEMORY RESET
ALL
MEMORY RESET
FONTS/GRAPHICS
or:
MEMORY RESET
PAGES/FORMATS
C o d e 3 9
Troubleshooting
9
9-17