Dark Adjust, Set; End-Of-Print Skip Distance, Set - Intermec 4400 User Manual

4400 Bar Code Label Printer User's Manual
Cutter, Enable or Disable (continued)
Notes: To make this command effective, reset the printer or cycle the power after
issuing this command.

Dark Adjust, Set

Purpose: Sets the dark adjust command. This controls the print darkness on the labels.
Default: n = 0
Syntax:
<SI>d n
n ranges from -10 to 10.
Notes: This command changes the setting in configuration.
This command becomes effective upon execution.

End-of-Print Skip Distance, Set

Purpose: Sets the end-of-print skip distance. This distance is a number in dot size
increments that the label advances after printing. This command works for gap,
mark, or continuous label stock.
Default: n = 0
n = 141
Syntax:
<SI>D n
n must be a number from 0 to 9999 in dot size increments.
This command is effective upon execution.
Notes:
To advance the label out to the tear bar in label stock mode, set n to 131.
If you enter a value for n, it applies to both continuous mode and label stock
mode, regardless of the mode in which the value was entered.
Entering the <SI>D command without setting any parameters returns the
setting to its default value.
This command is ineffective in Self-Strip and Cutter applications.
7-36
Label stock mode
Continuous stock mode