Printing A Configuration Test Label; Powering Up Your Printer - Intermec 4400 User Manual

4400 Bar Code Label Printer User's Manual

Printing a Configuration Test Label

Before you install your printer and connect it to your data collection system,
you should print a configuration test label. This label provides you with a copy
of the current configuration settings. You will need to know these settings
when you install your printer and incorporate it into your system.
Note: These instructions for printing a configuration test label are identical to those in
the Getting Started Guide. If you have already followed the procedures in the Getting
Started Guide, you can skip to the next chapter.
To print a configuration test label, follow these steps that are described in the
next sections:
1. Power up the printer.
2. Open the printer.
3. Load media.
4. Close the printer.
5. Print the label.

Powering Up Your Printer

1. Plug the AC power cord into the receptacle on the back of the printer. Plug
2. Set the power switch (located on the back panel of the printer) to the on ( l )
1-10
the other end into a wall outlet or surge protector.
position. When the printer is fully powered, the Power and Online
indicator lights are lit and the display reads as follows:
PAPER FAULT
Note: All three indicator lights, including the Alert light, flash when you turn on
the printer.