Using The X And Y Forms Adjust - Intermec 4400 User Manual

To adjust the darkness of your labels
1. Start at the ONLINE READY display:
2. Press [MENU] to enter the Operator menu. Press [ ] or [ ] until the display
3. Press [SELECT]. The display shows the current dark adjust setting with an
4. Press [ ] to increase the number and darken the printing. Press [ ] to
5. Press [ENTER] at the desired setting. The asterisk (*) moves to the new
6. Press [CONTINUE] to return to the ONLINE READY display. Print out a
7. If the labels are too dark or too light, repeat Steps 3 through 6.

Using the X and Y Forms Adjust

If the print on your labels is not positioned correctly, you can center the printed
image with the X and Y Forms Adjust. The X Forms Adjust lets you adjust the
position of the printed image in the direction of media movement (moves the
print further towards the front or back of the label). The Y Forms Adjust lets
you adjust the position of the print in the direction parallel to the front of the
printhead (moves the print towards the sides of the label). You can use X and Y
Forms Adjust when the printer is online or offline.
Note: Make sure you set the Label Width before you use the Forms Adjust command.
Refer to "Configuring the Label Width," in Chapter 5.
NugFont
HelvC
ONLINE
READY
shows:
OPERATOR MENU
DARK ADJUST
asterisk (*) as shown in the example below:
DARK ADJUST
5*
decrease the number and lighten the printing. The range is from -10
(lightest) to 10 (darkest).
setting as shown in the example below:
DARK ADJUST
3*
few labels. You may want to scan some labels to see if they are too dark or
light to scan.
C o d e 3 9
Operating the Printer
4
4-21