Restoring Printer Default Configuration - Intermec 4400 User Manual

4. Press [ ] or [ ] until the display shows:
5. Press [SELECT]. The display shows:
6. Press [SELECT]. The display shows:
7. Press [ENTER] to print the configuration test label. A sample label is shown
8. To exit from the Service Menu, press [CONTINUE]. The display shows:
9. Turn off the printer. Save the configuration test label for reference when
If you have trouble printing your configuration test label, try restoring the
default configuration using the procedure in the next section.

Restoring Printer Default Configuration

If your configuration test label is not satisfactory, or if you have trouble
printing, your printer may have lost its configuration during shipment.
To restore the factory default setting
1. Start at the OFFLINE READY display (press [ONLINE/OFFLINE] if
2. Press [MENU]. Then press [ ] or [ ] until the display shows:
3. Press [SELECT]. Then press [ ] until the display shows:
4. Press [SELECT]. The display shows:
NugFont
HelvC
SERVICE MENU
PRINT CONFIG
PRINT CONFIG
USER DEFINED
USER DEFINED
EXECUTE TEST
in Chapter 5 under "About Configuration Test Labels."
OFFLINE
OFFLINE READY
you install and configure the printer.
necessary).
OFFLINE
SERVICE MENU
SERVICE MENU
MEMORY RESET
MEMORY RESET
ALL
C o d e 3 9
Getting Started
1
1-15