Adjusting The Label Rest Point - Intermec 4400 User Manual

5. Press [ENTER] at the desired setting. The asterisk (*) moves to the new
6. Press [CONTINUE] to return to the ONLINE READY display. Print out a
7. If the print is not positioned properly, repeat Steps 3 through 6.

Adjusting the Label Rest Point

This command is used mostly with the Self-strip option. If you are using Self-
Strip, you may find that your labels are not stopping at the right point for
removal and you are tearing off part of a label each time you remove one from
the printer. Adjusting the label rest point changes the point at which labels are
presented for removal.
To adjust the label rest point
1. Start at the ONLINE READY display:
2. Press [MENU] to enter the Operator menu. Press [ ] or [ ] until the display
3. Press [SELECT]. The display shows the current Label Rest Point setting
4. Press [ ] to increase the number and move the labels farther before tearing
NugFont
HelvC
Note: The range for the X Forms Adjust is from -20 (furthest towards the front) to
+20 (furthest towards the back). The range for the Y Forms Adjust is from -30
(closest to the top) to +30 (closest to the bottom).
setting as shown in the example below:
X FORMS ADJUST
3*
few labels.
ONLINE
READY
shows:
OPERATOR MENU
LABEL REST POINT
with an asterisk (*) as shown in the example below:
LABEL REST POINT
0*
them off. Press [ ] to decrease the number so the labels do not move as far
forward before you tear them off.
Note: The range for the Label Rest Point is from -30 to +30 dots.
C o d e 3 9
Operating the Printer
4
4-23