Self-Strip, Enable Or Disable; Top Of Form, Set; Ttr Or Direct Thermal, Select - Intermec 4400 User Manual

4400 Bar Code Label Printer User's Manual

Self-Strip, Enable or Disable

Purpose:
Default:
Syntax:
Notes:

Top of Form, Set

Purpose:
Default:
Syntax:
Notes:

TTR or Direct Thermal, Select

Purpose:
Default:
Syntax:
Notes:
7-44
Turns the Self-Strip option on or off. The Self-Strip option must first be
installed from the control panel.
n = 0
<SI>t n
n = 0 Disables the self-strip option.
n = 1 Enables the self-strip option.
This command becomes effective after the printer is reset or the printer power
is cycled.
Sets the top-of-form (left margin) to n which is the distance, in dot increments,
from the label origin to its leading edge.
n = 20
<SI>F n
n must be a number from -10 to 4000 dot increments. The negative values let
you decrease the margin and print closer to the edge of the label.
This command is effective upon execution.
Selects the label stock to be used.
n = 0
m = 420
<SI>g n,m
n selects the stock to be direct thermal (DT) or thermal transfer (TTR)
n = 0 Direct thermal
n = 1 Thermal transfer
,m sets the sensitivity. See Chapter 4 for details on how to set this parameter.
This command becomes effective after the printer is reset or the printer power
is cycled.