Restoring Printer Default Configuration; Memory Reset - Intermec 4400 User Manual

Restoring Printer Default Configuration

To return the 4400 printer to its default configuration settings, follow the
"Memory Reset" procedure outlined below. A complete table of the default
settings follows on the next page.

Memory Reset

1. Start at the OFFLINE READY display.
2. Press [MENU]. Then press [ ] or [ ] until the display shows:
3. Press [ ] until the display shows:
4. Press [SELECT]. The display shows:
5. Press [ ] until the display shows:
6. Press [ENTER] to reset the configuration settings.
Note: After using Memory Reset to restore the printer default configuration, you must
reinstall the software drivers for options such as the Cutter or Self-Strip. Memory
Reset also resets all parameters to their default settings, as listed in the table following
this procedure. Sensitivity will be set at 420. See Chapter 8 for procedures on
reinstalling the options' software drivers.
NugFont
HelvC
OFFLINE
SERVICE MENU
SERVICE MENU
MEMORY RESET
MEMORY RESET
ALL
MEMORY RESET
CONFIGURATION
C o d e 3 9
Configuring the Printer
5
5-19