Intermec 4400 User Manual page 135

NugFont
HelvC
The <STX> and <ETX> characters mark the beginning and end of each
command string. The semicolon (;) is the command terminator. All commands
in Program mode must end with this terminator except the last command in a
message. The other characters are described in the table below.
Command Description
<ESC>C Sets 4400 (advanced) mode.
<ESC>P Enters Program mode.
E3; Erases anything previously stored as format three.
F3; Creates format three.
H0; Designates field zero as a human-readable field.
o162,200; Sets the origin at grid coordinates (162,200).
f0; Sets the field rotation to zero, which is unrotated or horizontal.
c2; Selects internal font two.
d0,16; Determines that data is sent during print mode and its maximum length is 16
characters.
h2; Sets the height magnification factor to twice its original height.
w2; Sets the field width magnification factor to twice its original width.
H1; Defines field one as a human-readable field.
o162,300; Sets the field origin at coordinates (162,300).
f0; Sets the rotation factor of the field to zero.
c2; Selects internal font two.
d3,Warehouse Determines that data for the field has this constant value: Warehouse Part # 3666.
Part # 3666;
h2; Sets the field height magnification factor to twice its original height.
w2; Sets the field width magnification factor to twice its original width.
B2; Defines field two as a bar code field.
o162,400; Sets the origin at coordinates (162,400).
f0; Sets the field rotation to zero (unrotated).
c0,1; Selects Code 39 with a check digit entered by the printer.
h100; Sets the field height to 100 dots.
C o d e 3 9
Designing Labels and Using Commands
6
6-25