International Character Sets; 4400 Character Table - Intermec 4400 User Manual

Signal Pin Return
BUSY 11 29
PE 12 30
SELECT 13 -
CHASSIS 17 -
GND
INIT 31 16
FAULT 32 33
Note: The maximum cable length for a parallel interface is 10 feet. The parallel
interface only allows one way communication with the printer. You may download
from the host terminal, but you cannot upload from the printer.

International Character Sets

The following tables show which hex codes to download for international
characters not available in the U.S. character set. To use the tables, find the hex
code for the U.S. character that corresponds with the character in your
language.

4400 Character Table

If you are running your printer in 4400 mode (you are not using 86XX
emulation), use this table to find the right hex codes for the international
character sets.
Direction Description
OUT If HIGH, printer cannot receive data.
OUT If HIGH, out of ribbon or media.
OUT Pulled to +5V. Printer is on.
- Printer's chassis gnd isolated from logic gnd.
IN Clears I/OINT0 latch.
OUT See printer display.
A
Appendix
A-13