Options Software Drivers; Loading Options - Intermec 4400 User Manual

4400 Bar Code Label Printer User's Manual
Installing an option software driver is different than the option enable/disable
commands in the Configuration menu, since the option is fully installed, not
just enabled or disabled.
Note: It is important to load only those software drivers for the options with which
your printer was configured.

Options Software Drivers

This table lists the options software drivers. Default values are in bold.
Command
External Options

Loading Options

You do not need to do this procedure if the driver is installed, but disabled.
To load options
1. Start at the OFFLINE READY display.
2. Press [MENU]. Then press [ ] or [ ] until the display shows:
3. Press [SELECT]. Then press [ ] or [ ] until the display shows:
4. Press [SELECT] to enter the options menu.
5. Press [ ] or [ ] to choose external options.
6. Press [SELECT] at the type of option you are installing. The display shows
7. Press [ ] or [ ] until you see the option you are installing, and then press
8. To load another type of option, press [MENU] and return to Step 4. Press
8-14
Selections
None, Self-Strip, Cutter
OFFLINE
INSTALL MENU
INSTALL MENU
OPTIONS
the current setting with an asterisk (*) as in the example below:
EXTERNAL
NONE*
[ENTER] to move the asterisk (*) next to the selection as shown below:
EXTERNAL
SELF-STRIP*
[CONTINUE] to return to the OFFLINE READY screen.