Intermec 4400 User Manual page 250

4400 Bar Code Label Printer User's Manual
Error Message Problem
The self-strip option is not connected.
self-strip not
connected
If you are using the cloning or selective
sender error
transfer commands, the Sender printer is
not set up properly to send information
to the Receiver.
The printer microprocessor has detected
state fault
an internal fault.
The printer microprocessor has detected
struct fault
an internal fault.
The eight Syntax Error messages are
SYNTAX ERROR
listed below. See Chapters 6 and 7 for
information on command syntax. In all
cases, press [CONTINUE] to clear the
alert.
Problem
24 Missing preamble or postamble data.
33 Invalid field delimiter. Either a start or
end character is missing or they are
different types.
34 Invalid escape command.
35 Invalid shift command.
44 Semicolon (;) missing after <ESC>P.
46 Statement does not make sense.
54 Invalid UDC command.
The printer microprocessor has detected
trace fault
an internal fault.
The printer microprocessor has detected
type fault
an internal fault.
9-12
Solution
Make sure the self-strip is connected
properly, or disable the option (refer to
Chapter 5). Press [FEED/RELOAD] to
clear the alert.
Check all connections between the
Sender and the Receiver printers. Make
sure the Sender printer is set up correctly
for transmitting information to the
Receiver.
Call your Intermec Product Support
Representative.
Call your Intermec Product Support
Representative.
Solution
Delete the setup for preamble or
postamble data, or include the data.
Check for all pairs of field delimiters and
make sure both are numeric, or both are
alphanumeric.
Correct the escape command syntax.
Correct the shift command syntax.
If data follows <ESC>P you must insert a
semicolon (;) to separate commands.
Check the statement syntax.
Correct the UDC command syntax.
Call your Intermec Product Support
Representative.
Call your Intermec Product Support
Representative.