Intermec 4400 User Manual page 49

NugFont
HelvC
To change the main port settings, you must use the control panel to reach the
selections in the main port menu.
To change any of the values listed in the previous table
1. Start at the OFFLINE READY display.
2. Press [MENU]. Then press [ ] or [ ] until the display shows the following:
OFFLINE
INSTALL MENU
3. Press [SELECT]. The display shows:
INSTALL MENU
SECURITY
4. Press [ ] or [ ] until the display shows the following:
INSTALL MENU
MAIN PORT
5. Press [SELECT]. The display shows the following:
MAIN PORT
BAUD RATE
6. Press [ ] or [ ] to scroll through the available commands.
7. Press [SELECT] when you reach the command you want to change. The
display shows the current setting with an asterisk (*).
8. Press [ ] or [ ] to scroll through the available settings for the command.
9. When you see the setting you want, press [ENTER]. The asterisk (*)
appears next to the new setting, indicating it is now active.
10. Press [CONTINUE] to return to the OFFLINE READY display or, to change
other settings, press [MENU] and repeat Steps 6 through 9.
Note: You must cycle the printer power (turn the printer off and then on again) to put
any changes into effect. Cycling the power after making a number of changes activates
all of them at once.
C o d e 3 9
Installing the Printer
2
2-13