Intermec 4400 User Manual page 245

Error Message Problem
The printer's main microprocessor
80186 rom
cannot access ROM. Printing stops and
error
the control panel locks up. When the
printer power is cycled, this message
appears.
One of the printer's microprocessors
80960 ram
cannot access RAM. Printing stops and
error
the control panel locks up. When the
printer power is cycled, this message
appears.
One of the printer's microprocessors
80960 rom
cannot access ROM. Printing stops and
error
the control panel locks up. When the
printer power is cycled, this message
appears.
There is not enough voltage reaching the
ac volts low
printer through the AC power cord.
The Ambient Temperature Sensor is
ambient temp
disconnected or not working properly.
sensor fault
The printer microprocessor has detected
calls fault
an internal fault.
Portions or all of the static memory were
checksum error
found to be corrupted and were reset.
Some or all of the fonts, UDCs, formats,
configuration settings, etc., may have
been lost.
NugFont
HelvC
C o d e 3 9
Troubleshooting
Solution
Cycle the power again. If the message
reappears, turn off the printer and
contact your Intermec service
representative.
Cycle the printer power again. If the
message reappears, turn off the printer
and contact your Intermec service
representative.
Cycle the printer power again. If the
message reappears, turn off the printer
and contact your Intermec service
representative.
Test the line voltage. If sufficient voltage
is reaching the printer, then the problem
is internal to the printer and you should
contact your Intermec service
representative. If the printer is not
receiving sufficient voltage, replace the
power cord.
The printer will still operate but you
cannot clear the alert. Contact your
Intermec representative.
Call your Intermec Product Support
Representative.
Call your Intermec Product Support
Representative.
9
9-7