Configuration Commands; 86Xx Or 4400 Mode On Power Up - Intermec 4400 User Manual

Configuration Commands

Configuration commands, like Print mode commands, are effective when the
4400 is in Print mode. Use configuration commands to:
Configuration commands come into effect when the printer is reset or the
power is cycled. If a printer reset is needed, the warm boot command should
be used. The reset will take place after all previous commands have been
executed. This contrasts with the <DLE> reset command, which executes
immediately after it is received even if other commands are waiting to be
executed. The command string to enter Print mode from Program mode is:
<STX>R<ETX>
Note: Each string of commands must be preceded by the start of message character
<STX>, and followed by the end of message character <ETX>. All configuration
commands are terminated by the next command in the message.
The following command descriptions explain the configuration commands that
are effective when the printer is in Print mode. The command descriptions are
listed in alphabetical order.

86XX or 4400 Mode on Power Up

Purpose: Selects 86XX or 4400 printer mode on power up.
Default: n = 1
Syntax:
<SI>C n
n = 0
n = 1
Notes: To make this command effective, reset the printer or cycle the power after
issuing this command.
NugFont
HelvC
Set parameters for configuration features.
Enable or disable options.
Selects 86XX printer mode.
Selects 4400 printer mode.
C o d e 3 9
Printer Commands
7
7-33