Intermec 4400 User Manual page 247

Error Message Problem
This message appears when the Media
media alert
Alert feature has been enabled and the
media supply needs to be replenished.
Portions or all of the static memory were
memory reset
found to be corrupted and were reset.
Some or all of the fonts, UDCs, formats,
configuration settings, etc., may have
been lost.
The printer microprocessor has detected
Operation
an internal fault.
fault
The five overflow error messages are
overflow error
described below. Press [CONTINUE] to
clear the alert.
Problem
32 Non-immediate command or data
received with full buffer.
37 Not enough room in the printer memory
to print the label format. The format fits
into memory but there is not enough
memory left to print.
42 Not enough room in the printer memory
to store the format.
43 Too many fields in the label format.
53 Not enough room for graphic or user-
defined font in the label format.
NugFont
HelvC
C o d e 3 9
Troubleshooting
Solution
Replenish the media supply. Refer to
Chapter 4. To disable this feature, refer
to Chapter 5. Press [FEED/RELOAD] to
clear this warning.
Call your Intermec Product Support
Representative.
Call your Intermec Product Support
Representative.
Solution
Resend message after buffer has cleared.
Reduce the format complexity by
deleting fields or decreasing the amount
of data.
Delete any formats, fonts, or graphics
that you no longer need. If the format
still does not fit, delete a few fields or
other data from the format.
Note: To see how much printer memory is
available, enter <ESC>m at the host.
Delete some fields, or reduce the number
of characters in the fields.
Delete any formats, fonts, or graphics
that you no longer need. If there is still
not enough room, reduce the size of the
font or graphic.
9
9-9