Printing The Hardware Configuration Test Label - Intermec 3400 User Manual

Printing the Hardware Configuration Test Label

You can print the hardware configuration test label to test the printer and make
sure it is operating correctly. The hardware configuration test label lists the
printer's configuration. Use this label for reference when installing your printer
and for verification of proper printer operation.
To print the hardware configuration test label
1. Turn the On/Off switch to the off position.
2. Press and hold the Feed/Pause button while you turn the On/Off switch to
3. Release the Feed/Pause button when the media starts moving. The printer
4. Turn the printer power off and then on. You are now ready to connect your
Hardware Configuration Test Label
NugFont
HelvC
the on position. The Alert and Empty/Pause LEDs blink during the printer
self-test.
feeds out one or two blank labels and then prints the hardware
configuration test label.
3400, 3440, or 3600 printer to your system.
3440 Hardware Configuration
Memory Installed
: 256 kilobytes
Storage RAM
: 583 kilobytes
Image RAM
: none
Flash RAM
Mileage
: 0
Inches Processed
: 0
Inches Burned
: 0
Labels Cut
Printhead
: 1792 dots
Width
: 2.5 mil
Dot Size
: 156
Burn Pot Setting
Hardware Options
: none
I/O Option
: none
Internal Option
: none
External Option
Firmware Checksum
: 95D0
ROM0 (U21)
: 7331
ROM1 (U9)
: 062933
Program
: 0.a
Version
Note: This is only an example of a hardware configuration label. Your label may
not be exactly the same.
C o d e 39
Getting Started
1
3XXXU.007
1-9