About Test Labels; Print A Test Label With The Icon Printer; Print A Test Label With The Full Touch Printer - Intermec PM43 User Manual

About Test Labels

Print a Test Label with the Icon Printer

Print a Test Label with the Full Touch Printer

PM43 and PM43c Mid-Range Printer User Manual
Print a test label after you have loaded media and ribbon to verify that
you have installed everything correctly and also to get some important
information about your printer. The way you print a test label is
slightly different between the full touch and the icon printer. Please
use the procedure for your printer.
When you turn on the icon printer, all of the LEDs on the display light
up including the Ready-to-Work indicator. One by one, the LEDs turn
off as the printer starts up. The first LED to turn off is the Ready-to-
Work indicator. The LEDs then turn off following a sequence from the
top left LED to the bottom right LED.
1 Connect the printer to power and turn on the printer.
2 The printer goes through its startup sequence and all of the LEDs
light up. When the last two LEDs are lit (Printhead Hot and
Maintenance), press and hold the Print button until the test label
starts to print.
3 Release the Print button.
The series of three test labels prints out.
The first time you turn on the full touch printer or reset to factory
defaults, the printer runs a startup wizard to let you enter basic setup
information. After the startup wizard finishes, the printer enters Ready
mode where you can choose to access the Main Menu and print a test
label.
1 Connect the printer to power and turn on the printer.
2 After the startup sequence finishes, the startup wizard begins. After
you enter all of the information on the wizard screens, click No
when prompted to run other wizards.
3 From the Ready screen, tap the Main Menu button on the status
bar.
Chapter 2 — Set Up the Printer
35