Paper Low; Configuration; Power Up Emulation; Print Speed - Intermec EasyCoder PX4i User Manual

Configuration

EasyCoder PX4i User's Guide (IPL Version)

Paper Low

Specifies the diameter in millimeters of the media supply roll for
the paper sensor. When the diameter of remaining media supply
reaches the set value, an SNMP trap is sent to the printer's home
page, provided the printer has an optional EasyLAN connection.
Range: 0-150 with preset values at an interval of 10. A value
larger than 150 sets the paper sensor to 0. Default value: 0.
The ribbon low sensor can also be set using an IPL command:
<STX><SI>jn<ETX>

Power Up Emulation

The emulation mode lets you print bar code labels that were
originally designed on an 86XX printer in multiples of 10 or 15
mil. When the printer is working in emulation mode, not all IPL
commands are supported. For a complete list of commands
available during emulation mode, see the latest version of the IPL
Programming Reference Manual (P/N 066396-xxx).
To return from emulation mode, select emulation "none"
(default).

Print Speed

You can select the print speed from 4 in/sec (100 mm/sec) to 12
in/sec (300 mm/sec) with an interval of 1 in/sec. The higher the
print speed, the more wear on the printhead, so do not use a
higher print speed than necessary. Some direct thermal media or
ribbon/media combinations may not allow the highest
alternatives without the printout quality being adversely affected.

Cutter (option)

By default, "Not Installed" is displayed. If a cutter is installed,
you must manually indicate that condition to the firmware by
selecting either "Enable" or "Disable." Once you have done that,
you can also use IPL commands to enable or disable the cutter:
<STX>R<ETX> enter print/configuration mode
<STX>c0<ETX> Disable cutter
<STX>c1<ETX> Enable cutter
Chapter 6 — Setting Up the Printer
67