Setting Configuration Commands In Test And Service Mode - Intermec EasyCoder 3400e User Manual

C d

Setting Configuration Commands in Test and Service Mode

EasyCoder 3400e Bar Code Label Printer User's Manual
39
Helvetica CondensedHelvetica
To use memory reset
1 Turn the printer off.
2 Press and hold the Feed/Pause button while turning on the printer. The
printer prints a hardware configuration test label.
3 Set the DIP switches to reset a portion or all of the memory by using
the Test and Service Mode DIP Switch Settings illustration on page 57.
4 Hold the Feed/Pause button down for 1 second. The printer resets a
portion or all of its memory.
Test and Service mode also provides you with an alternative to using
PrintSet or sending configuration commands down from the host. You can
change these configuration commands by setting the Test and Service
mode DIP switches:
• Label rest point
• 86XX emulation
• X forms adjust
• Y forms adjust
O = OFF
1 = ON
Label Rest Point
Adjust Forward
Adjust Backward
86XX Emulation
Advance Mode
10 Mil
15 Mil
X Forms Adjust
Adjust Forward
Adjust Backward
Y Forms Adjust
N: Number. Least significant bit first.
Configuration DIP switch settings: This illustration shows the Test and Service mode
DIP switch settings for changing the configuration commands.
Chapter 6— Using Test and Service Mode
Top Bank
OFF
ON
1 2 3 4 5 6 7
O 1 1
O
1
1 O 1
O O
1 O
1 1
1
1 1 1
O
1
1 1 1 O
Bottom Bank
8 1 2 3 4 5 6 7 8
N N N N N
N N N N N
N N N N N
N N N N N
N N N N N
3XXXU.046
59