Special remarks
Auto rotate and auto paper detect settings
If either autorotate or autopapersize is turned on for an RCF file, the settings
will NOT remain permanently on. The settings take hold temporarily and
override the job defaults.
This applies to queuing only. Manually printing RCFs can override the RCF
settings, but it will not change the job defaults.
Optional RCF override
When Repro Desk is in job-mode, the main menu will contain an option to
ignore all information in RCF headers. This setting is used for all jobs, so it is
not possible to have one job open where all RCF headers are ignored and one
job where the information from RCF headers is used.
Priority of RCF versus other settings
The following description is for the case when 'Ignore RCF Headers' is
Note:
NOT selected.
The general guideline for manipulating files goes like this: The 'closer' the
information is to the file, the higher precendence it has. So, we come up with
this order:
RCF header
1
Polling queue settings
2
Job settings (sending through a job is a different path than through a polling
3
queue, so it is tied for second).
Queue settings
4
Supported RCF commands
443
Need help?
Do you have a question about the Repro Desk and is the answer not in the manual?