Scan
Scan a document
Make the required settings in the dialogue box.
1
Click Start Scan Set button to start scanning.
2
The status bar displays Load document 1. When the scanner has finished
scanning the first document it displays Load document 2, and so on until you
have finished.
While scanning, the Start Scan Set button changes to Stop Scan Set. Click this
button if you want to pause scanning. Click the button again to resume where
you left off.
When the message "Load Doc 1" is visible on the operating panel, insert the
3
original in the scanner.
Press the Start button on the scanner operating panel.
4
Repeat inserting an original until you have scanned all your originals.
5
Click Exit Scan mode when you have finished scanning to close the scan
6
documents dialogue box.
Océ scanner configuration
established communication, the Océ scanner settings are automatically
detected by Océ Repro Desk and displayed in the relevant fields: Scan width,
Scan length, Scan size, File size, Original width, Auto length, Zoom info and
Trailing edge.
Realtime viewing
progress in the viewer. Using the viewer does not make the scanning slower so
using it or not is a matter of personal preference.
Greyscale viewing
number of grey scale gradients to render the scanned in drawing instead of
using solid black. This option gives a far better view of the original drawing.
Allow tiled TIFF
drawing to a standard image size.
Often drawings will be slightly smaller than a truly standard paper size. In the
U.S., a 30 inch x 42 inch drawing is a commonly used size. For many reasons,
a drawing to be scanned may be slightly undersized. So if a customer had a
drawing that actually measured 29.5 x 41.5, the image should actually be 30 x
42.
400
Océ Repro Desk User Manual
When the scanner and Océ Repro Desk have
Check Realtime viewing if you want to see the scanning
If you select this option, the realtime viewer will use a
Selecting this option permits the user to scan a non-standard
Need help?
Do you have a question about the Repro Desk and is the answer not in the manual?