Scanning Non-Standard Size Originals - Oce Repro Desk User Manual

Scanning non-standard size originals

The scanner of the Océ 9800 automatically detects the width of the inserted
original. For European sizes, for example, it detects whether the width is A0,
A1, A2, A3, A4, 500 mm, or 700 mm (or 707 mm, depending on the
configuration). The Océ Repro Desk system uses a memory table that contains
all standard width and standard length combinations to predict the length of the
original. The scanner also measures the real length of each original while it is
transferred through the scanner.
If you are copying thick originals or originals in a carrier sheet, it is
Note:
recommended to use the output at the rear side of the scanner to ensure correct
delivery.
Depending on the original, you must define both the original size and the
original length as specified below:
Standard original:
Original width
Original length
Standard width, non-standard length:
Original width
Original length
Non-standard width, non-standard length
Original width
Original length
The original length is automatically set by the scanner for option 1.
Note:
Selecting non standard original width (option 1) may cause some white
Note:
space along your image. To prevent this, you can specify the exact width
yourself (option 2).
If your scanner is equipped with 5 sensors instead of 8 sensors, it can not
Note:
discriminate between 700mm, A0 and 36". In that case always specify the
original width yourself (option2) to scan a 700mm or A0 original.
Scan 9800/9600
Standard
Standard
Standard
Automatic
Option 1
Non-standard
-
Option 2
Custom
Automatic or Custom
423