Oce Repro Desk User Manual page 427

Make sure the 'auto zoom' and 'auto roll' buttons are not selected.
3
Make other settings as required.
4
Feed the original.
5
It is also possible to adjust the length of the leading edge to eliminate a filing
strip. The leading edge can be shortened up to 100 millimetres.
Scanning with removed filing strip along the leading edge
Open the 'Copy size' card in the 'Copy' section.
1
Press the function button 'Remove strip' twice (see figure 311).
2
Copies:
Ready to copy
0
Image
Special
original
Copy
material
......................................................................................................................................
Copy
size
[311] Removing strip
Adjust the values in millimetres for the leading edge using the numeric or the
3
higher/lower buttons.
Scanning with removed filing strip along the trailing edge
remove the trailing edge, you can use the 'Remove strip' setting for the leading
edge as described above, and feed the original with the trailing edge first. Then
use the Océ Viewer to rotate the scanned image 180°.
You can also define the original width and length.
Note:
Scan 9800/9600
................
Machine
A4 >> A4
A3 >>
A3
210 mm
A2
A2 >>
A1 >> A1 Standard cut
A0
A0 >> Synchro cut
Copy
Auto format
selection selection length
length
................
................
Program Finishing
4 mm
0 mm
Remove
strip
If you want to
................
Copy
0 mm
0 mm
Add
strip
427