Event Notification; Configuring E-Mail Notification - Brocade Communications Systems Brocade BladeSystem 4/24 User Manual

10

Event notification

Event notification
The Management application records the SAN events in the Master Log. You can configure the
application to send event notifications to e-mail addresses at certain time intervals. This is a
convenient way to keep track of events that occur on the SAN. You can also configure products to
"call home" for certain events, notifying the service center of product problems. For instructions
about configuring call home for events, refer to

Configuring e-mail notification

To send notification of events to users, complete the following steps.
1. Select Monitor > Event Notification > E-mail.
FIGURE 104
2. Select the Enable E-mail Event Notification check box.
3. Enter the IP address or the name of the SMTP mail server that the Server can use to send the
4. Select the SMTP over SSL check box to enable secure communication.
5. Enter the authentication ID of the SMTP mail server in the SMTP ID field.
6. Enter the authentication password of the SMTP mail server in the SMTP Password field.
7.
274
The E-mail Event Notification Setup dialog box displays
E-mail Notification Setup dialog box
e-mail in the E-mail Server field.
NOTE
This field is optional unless the SMTP server enables authentication.
NOTE
This field is optional unless the SMTP server enables authentication.
Enter the recipient's e-mail address in the Reply Address field.
"Call Home" on page 105.
(Figure 104).
DCFM Enterprise User Manual
53-1001775-01