Exporting The Public Key Certificate Signing Request (Csr); Importing A Signed Public Key Certificate From Properties; Enabling And Disabling The Encryption Engine State From; Properties - Brocade Communications Systems StoreFabric SN6500B Administrator's Manual

Exporting the public key certificate signing request (CSR) from

properties

To export the CSR under Public Key Certificate Request, complete the following steps.
1. Click Export, then browse to the location where you want to save the certificate and click Save.
2. Submit the CSR to a certificate authority (CA) for signing. CA signing requirements and

Importing a signed public key certificate from properties

To import a signed public key certificate, complete the following steps.
1. Click Import.
FIGURE 76
2. Enter or browse to the file containing the signed certificate, then click OK.
Enabling and disabling the encryption engine state from properties
To enable the encryption engine, complete the following steps:
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
2. Select an encryption engine from the Encryption Center Devices table, then select Engine >
Fabric OS Encryption Administrator's Guide (SKM/ESKM)
53-1002721-01
•
HA Cluster Name: The name of the HA cluster (for example, Cluster1), if in an HA
configuration. HA Cluster names can have up to 31 characters. Letters, digits, and
underscores are allowed.
•
Media Type: The media type of the encryption engine. Options are Disk and Tape, or
Disk/Tape when both are present.
•
Re-Balance Recommended: Indicates if LUN rebalancing is recommended for an
encryption engine that is hosting both disk and tape LUNs. Options are Yes and No.
•
System Card Status: The current status of system card information for the encryption
engine. Options are Enabled and Disabled.
Alternatively, you may also copy the CSR and paste it to a file.
procedures differ per key manager appliance.
The Import Signed Certificate dialog box displays
Import Signed Certificate dialog box
The file is imported onto the switch.
dialog box (Refer to Figure 1
Properties from the menu task bar, or right-click a switch or encryption engine and select
Properties.
Viewing and editing switch encryption properties
(Figure
on page 14).
76).
2
111