Enabling Or Disabling Snmp Informs; Adding A Syslog Recipient - Brocade Communications Systems WFT-2D User Manual

Enabling or disabling SNMP informs

To enable or disable SNMP informs, complete the following steps.
1. Select Monitor > SNMP Setup > Informs.
2. Select a product group from the Fabric / Products list.
3. Select a product in the SNMP Informs Capable Products list and click the appropriate Action
4. Click OK.
Syslogs
Use the Options dialog box to automatically register the Management application server as the
syslog recipient on all managed SAN and IP products. The syslog listening port number is 514 by
default. If you change the port number from 514, auto-registration is disabled.
NOTE
IronWare OS 6910 switches are not listed in the Syslog Recipient dialog box.

Adding a syslog recipient

The Syslog Recipients dialog box allows you to register any recipient as a syslog recipient on
selected products. You can register different recipients for different products.
You can register and unregister other recipient servers on the Fabric OS switches on a per-fabric
basis. For IP products, you can perform registration only at the switch level.
NOTE
IPv6 Syslog registration is not supported for IronView OS products.
To add a syslog recipient, complete the following steps.
1. Select Monitor > Syslog Configuration > Product Syslog Recipients.
Brocade Network Advisor SAN User Manual
53-1003154-01
The SNMP Informs dialog box displays.
The products display in the SNMP Informs Capable Products list, where you can determine if
the product's status is enabled or disabled.
button, depending on whether you want to enable or disable SNMP informs for that product.
The Syslog Recipients dialog box, shown in Figure 546, displays.
32
Syslogs
1275